Residential New Structure (RBLD), Addition/Alteration (RALT), Plan Check Only (PLCH)

Residential New Structure, Residential Addition/Alteration, and Plan Check Only, will require the following naming conventions.

Plans

  • This file should be named as follows:
    • Plans-RBLD2023-000xx.pdf
    • Plans-RALT2023-000xx.pdf
    • Plans-PLCH2023-000xx.pdf
  • This file to include, but is not limited to:
    • General Information
    • Civil
    • Architectural
    • Structural 
    • All applicable drawings associated with the permit.
      • Plumbing
      • Mechanical
      • Electrical
      • Energy Drawings
    • Any conditions of approval from the Land Use Permit. (if applicable)

Supporting Documentation

  • These files should be names as follows:
  • Not limited to:
    • Soils Investigation and/or Geotechnical Engineering Report
      • Soils Report-RBLD2023-000xx.pdf
    • Structural Calculations stamped and signed by the engineer
      • Structural Calcs-RBLD2023-00xx.pdf
    • Community Service District Will Serve Letters for water and sewer
      • Water Will Serve-RBLD2023-000xx.pdf
      • Sewer Will Serve-RBLD2023-000xx.pdf
    • Percolation Test (if applicable)
      • Percolation Test-RBLD2023-000xx.pdf
    • Title 24 Energy Report
      • T24 Energy-RBLD2023-000xx.pdf
    • ACCA Manual J, S, D 
      • ACCA Manuals-RBLD2023-000xx.pdf
    • Truss Calculations (if applicable)
      • Truss Calcs-RBLD2023-000xx.pdf
    • Project Manuals
      • Project Manuals-RBLD2023-000xx.pdf
    • Any or all applicable supporting documentation associated with the applied permit.

 

See Attaching Documents to a Permit on how to attach the plans via PermitSLO. Email County Staff contact when you have uploaded the plans.

The plans and supporting documentation must be labeled and packaged before uploading them for initial plan review. Submit a complete initial package only ONCE. Please verify that plans are sized for printing 24” x 36” sheets. Please verify that supporting documentation is sized for printing 8.5”x11” sheets. Staff will reject plans and supporting documentation if not submitted using the naming conventions above.

PLANS MUST HAVE A BLANK  2”H X 3”W  RECTANGLE ON THE LOWER RIGHT CORNER OF EVERY PAGE (IN THE SAME LOCATION) FOR COUNTY STAMP OF APPROVAL. IT IS THE RESPONSIBILITY OF THE PROFESSIONAL IN CHARGE, CONTRACTOR, AGENT, OWNER TO VERIFY COMPLIANCE WITH THIS REQUIREMENT.

After Inssuance Permit Submittal Procedure